Many manufacturers often provide customers with two kinds of structural choices when they promote their products. One is a gantry type and the other is a cantilever type. Most people think that the gantry type is better than the cantilever type, and it is mainly for stability and cutting accuracy. In fact, according to the reflection and actual comparison of most customers, there is no big difference between the two. In terms of cutting accuracy, the two are almost indistinguishable. On the contrary, since the gantry type screw has two motor drives, once the synchronization problem occurs, it will cause the deformation of the entire screw rod. In addition, the gantry type has more material than the cantilever type. Which one is best for water jet cutting?
There are many manufacturers who manufacture water jets in the market. How to choose good products among them should be started from the following points:
1, historical investigation. It depends on when the manufacturer started, that is, experience. Because the waterjet is a technological accumulation.
2, look at the plant and machinery, this does not need me to say, everyone should also understand.
3, listen to word of mouth, in this regard can not be found only from the network, because the network gunmen must be more than 10 million, it is best to ask from a friend.