The use of cutting platform installation equipment, as well as the maintenance and troubleshooting of the future water cutting machine platform have a far-reaching impact, therefore, the significance of the installation of the cutting platform is very important, the following will take the SQ3020 cutting platform as an example, the correct installation Proceed as follows:
1. To remove the water tank packing box, put the wire rope in the four rings of the water tank and lift the water tank to the work site.
2. Detach the platform side frame packing box (front frame, rear frame, left frame, right frame altogether 4 components), and lift the left and right side frames to the work site, and the front and rear side frames are transported to the work site with a forklift.
3. Unpack the high voltage generator, aluminum beam and industrial control box. Ship it to the work site with a forklift.
4. Requirements for use of cutting platforms The floor of the working site shall be at a substantially horizontal level, the thickness of the concrete layer shall not be less than 500 mm, and there shall be a running trough. For details, please refer to “Schematic Diagram of Installation of Water Cutters”.
5. The water tank should be placed in place according to the production process requirements, and then a horizontal ruler should be placed in the X direction and Y direction of the tank. The installer can adjust the horn so that the four corners of the tank are in the same horizontal plane. Adjust the frame and follow the bar.
6. Assemble the platform side frame, first place the front frame, the rear frame, the left frame, and the right frame in a rectangular manner, place the positioning pins in the four corners, fix the position, tighten the screws, and then lift the platform side frame to On the outside of the water tank, pad the horn as required, and use the level instrument on the platform side frame as the benchmark, and adjust the anchor bolts so that the four corners of the platform side frame are in the same horizontal plane.
7. Install the beam, lift the beam to the side support and tighten the fixing screws.
8. Connect all the cables, tubing, etc. in the side support, install the cover plate and piston pump, connect the industrial control electronic control box with the platform and the high voltage generator cable (seat number), and you can proceed to the next step.