Xusheng XS-046 sand removal system features:
1. De-sanding does not affect the normal cutting of the water jet
The sand removing device can place the sand suction nozzle into the water knife water tank while the water jet cutting work is performed, and the sand removal work can be performed. The removal of sand will not affect the normal operation of the waterjet. The equipment completely avoids the inconvenience of traditional sand-removing operations, the need to shut down the tank, the need to drain the tank water, dig the sand, and fill the water again, and it also earns valuable time for normal work.
2. Simple operation, thorough removal of sand, very fast
The equipment only needs 5 steps to complete the sand removal operation: 1. The equipment is in place. 2. The gas source is connected. 3. The sand suction nozzle is placed in the water tank. 4. The gas source switch is opened to remove the sand. After the sand is full, stop dumping the waste sand. The de-sanding rate of the equipment is above 90%. In the case of more sand accumulation in the tank, mud and other impurities (plastic paper, nylon mesh, etc.), it takes only 30 minutes to fill the entire tank.
3. Large capacity
The device has a diameter of 630mm, a height of 2.1M, and a sand removal of up to 460 liters. For example, 2X3M tanks can be reused after removing 3 to 4 tanks at a time.