Maintenance of the water cutter platform
1. Maintenance of the platform
1. The water cutting machine platform should always lubricate the linear guide, ball screw, nut support, etc. In principle, the machine needs to be manually filled once every 2 hours of continuous operation.
2. It is necessary to fill the oil pump frequently so that the oil level is not lower than the minimum oil level mark.
3. It is necessary to periodically remove the abrasive sand and the residual material deposited in the tank at least once a month.
4. The industrial computer should be used as a special machine for water cutting machine. The hard disk should have enough space to install anti-virus software, which can meet the needs of cutting complex parts.
5. It is necessary to protect the connection cable between the electric control box and the cutting platform and the high voltage generator. It is strictly prohibited to pedal or squeeze. The cable should be placed in the metal trunking.
6. Frequent replacement of the slats to affect the accuracy of the cutting.
7. Always fill the drain valve of the water tank to prevent the valve from rusting.
8. Keep the inside of the sand storage container dry. If the input sand pipe and the tank are filled with water due to the return water, all the sand in the sand storage container and the pipe must be removed, and then dried and filled with dry new sand.
9. After each day of work, clean up the site and make safe and civilized production.
The good use of the cutting platform and its careful and perfect maintenance will reduce the maintenance cost of the water cutting machine platform.