Waterjets cut out large slopes, and it's difficult to polish textures, especially complicated mosaics. How can you easily break them?
1. The water lines of all waterjets are inclined, and the three-axis waterjet machine will do so during the cutting process, especially when the speed is high or the slope of the cutter head is large. In this case, the sand can be replaced. The nozzle or try to slow down the speed, if it still can not meet the requirements, cut the side of the need to cut, and then it is not, it is recommended to buy a four-axis polishing. The 4 axis can correct the slope of the cutting edge, so that the waterjet cut out the side of the verticality is better, so that the seam of the mosaic is smaller. In terms of efficiency, the four axes are relatively high, and the reverse does not need to be polished. It helps the operator's health. Four-axis waterjet has a higher requirement for workpiece-to-tool height
Second, look at the slope of the cut is parallelogram or trapezoidal, if it is a parallelogram, the plate may be uneven, perhaps the table is not flat, can be replaced, if it is trapezoidal, then the height of the head is Not too high, or the pressure is not enough and the speed is too fast, so it will be more skewed, and look at adjusting the speed will not be better.
CENTER | HUAI'AN,CHINA