Waterjet cutting speed is a very complex problem, it is the result of a variety of factors together. Many consumers are concerned about the exact value of the cutting speed, but it is precisely not measured accurately. Under normal circumstances, the cutting speed of different materials and thicknesses is certainly not the same. If only from this point of view, the cutting speed can be calculated. However, there are other factors when cutting: sandblasting pipes, gems. The diameter of the sand tube is one of the factors that affect the cutting speed. In the case of normal pressure, the large diameter sand tube has a stronger cutting ability and the fastest speed.
Followed by the use of sand tubes and stones, because with the continuous erosion of high pressure water on the sand tube and gemstone, its pore size will change, resulting in changes in the water pressure and water column shape, thus affecting the cutting quality and speed. The use time of the two is different, and the cutting speed varies.
Therefore, the cutting speed of the water jet can not be measured accurately, but depends on the specific circumstances, and the manufacturers can provide the approximate speed of this product, consumers can continue to accumulate experience in actual use, the accuracy of the cutting speed Values ​​are empirically judged.